Front Page Forums Forum Uplynx Modules Uplynx RCZ2/4 GPIO trigger type

Ce sujet a 1 réponse, 1 participant et a été mis à jour par  AbelGill, il y a 4 mois.

2 sujets de 1 à 2 (sur un total de 2)
  • Auteur
    Messages
  • #10132 Répondre

    Ronald Hurtado

    Dear M2COMM friends,

    We are working with Uplynx RCZ2/4.

    We were doing trials with EasyAT commands to send some sigfox messages related to changes in GPIO ports.
    We notice that now they are level triggered. So how can we change this type mode to GPIO_TRIG_EDGE to be able to detect GPIO_FALLING_LOW or GPIO_RISING_HIGH?

    The current version we have is
    AT$V?
    Firmware Versionc 20170109_101451
    SIGFOX library version: UDL1-1.8.9

    Regards
    Ronald Hurtado

    #13543 Répondre

    AbelGill

    Hi…you want it in a place that won’t eventually sink into oblivion then the Wiki would be a good place. What I’m getting at is, perhaps initially, you could post it in the forum for peer review, and following that post it in the wiki. If you wanted to be fancy you create a github account and place it there.

2 sujets de 1 à 2 (sur un total de 2)
Répondre à : Uplynx RCZ2/4 GPIO trigger type
Vos informations:




© 2016 M2Communication Hosting. All rights reserved.

Click Me