Front Page Forums Forum Uplynx Modules Uplynx RCZ2/4 GPIO trigger type

This topic contains 1 reply, has 1 voice, and was last updated by  AbelGill 2 months, 1 week ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #10132 Reply

    Ronald Hurtado

    Dear M2COMM friends,

    We are working with Uplynx RCZ2/4.

    We were doing trials with EasyAT commands to send some sigfox messages related to changes in GPIO ports.
    We notice that now they are level triggered. So how can we change this type mode to GPIO_TRIG_EDGE to be able to detect GPIO_FALLING_LOW or GPIO_RISING_HIGH?

    The current version we have is
    AT$V?
    Firmware Versionc 20170109_101451
    SIGFOX library version: UDL1-1.8.9

    Regards
    Ronald Hurtado

    #13543 Reply

    AbelGill

    Hi…you want it in a place that won’t eventually sink into oblivion then the Wiki would be a good place. What I’m getting at is, perhaps initially, you could post it in the forum for peer review, and following that post it in the wiki. If you wanted to be fancy you create a github account and place it there.

Viewing 2 posts - 1 through 2 (of 2 total)
Reply To: Uplynx RCZ2/4 GPIO trigger type
Your information:




© 2016 M2Communication Hosting. All rights reserved.

Click Me